1. The mixer is installed smoothly and firmly. The walking wheel should leave the ground and the base should be higher than the ground.

2. The electrical equipment is good before starting, and the operation is idling until the mechanical operation is normal.

3. Add water when feeding in the middle of the operation. Do not start the material after adding the material. The feeding is not allowed to exceed the rated capacity.

4.the amount of feed, the tool can not hit the mixer, but also can not put the tool into the mixer during operation.

5. Do not enter debris in the hopper. When removing debris, it must be stopped.

6. If a fault occurs during operation, it should be shut down after power failure, find the cause, and do not use dangerous methods such as tool smashing to forcibly operate the machine.

7. The iron shed must be set at the inlet. It can't be removed at will. It needs to be installed immediately after removal. The mixer should be cleaned after work. The motor and electrical appliances should not be dampened during cleaning.

TRUSEEN,Loyally provide you with the best products and services.

Tel:0086-371-86238892 | +86 15617732826

Email:admin@truseen-machinery.com